Monday, January 25, 2010

Step 3

Last step: Lay out to dry, may take several hours. (don't box yourself in) After paper is dried you can spray a fixative to keep metallic powders in place. I had to do this......



Step 3: When you get a nice design in the water act quickly and carefully lay a piece of paper over the surface. If the paper is soft start in one corner, if it is ridged just set it in flat. Once the entire surface is laying flat on the water pick it up and wait a few seconds to let the excess water drip off then turn over to see results.

No comments:

Post a Comment